|
Post by massy on Jun 13, 2021 21:27:07 GMT
her is a bond cover update , this is the first reliant cover i have changed, your thoughts, cheers 
|
|
|
Post by cdb15 on Jun 13, 2021 22:24:12 GMT
Shouldn't those letters be the other way around ... ?
(just kidding!)
I presume you pressed the original flat in the centre panel and then used a new die to press the new letters. Looks a neat job. The only danger is if the metal gets too stretched at some point that coincidentally is on a letter edge in both words, but the easiest way to find out is to try it. Looks good!
|
|
|
Post by massy on Jun 16, 2021 21:38:06 GMT
hi cdb15 nearly guessed correctly, but not quite, it was stretched originally with a die press from factory , and in fact the reliant pressing has been shrunk back to is original state, and no its not repressed in with the bond logo, i did it another way, but thanks anyway rds
|
|
|
Post by rogeru7 on Jun 16, 2021 21:44:40 GMT
So did you make a new plate with the BOND pressed in then spot weld it over the area where the RELIANT wording was
|
|
|
Post by cdb15 on Jun 17, 2021 14:10:47 GMT
hi cdb15 nearly guessed correctly, but not quite, it was stretched originally with a die press from factory , and in fact the reliant pressing has been shrunk back to is original state, and no its not repressed in with the bond logo, i did it another way, but thanks anyway rds Well if the RELIANT has been 'squashed flat' as it were, and you didn't then stretch out the BOND letters, and if you haven't added a second thickness to the central panel pre-pressed with BOND as per rogeru7, then either you've added individual letters B, O, N and D to the now flat central panel, or you've cut out the central panel and welded in a complete new panel piece, pre-pressed with BOND.....
OR....
it's a hologram, and the entire cover is in fact not really there...
OK, go on, then, I give up!
|
|
|
Post by rogeru7 on Jun 21, 2021 19:53:23 GMT
Hi Massy so are you going to let us in on how you fitted, pressed or applied the word BOND to the cover
|
|
|
Post by massy on Jun 21, 2021 20:54:45 GMT
cheery top section then 25ton to press then i had cut heat resistant stickers. then 2k prime and 2k solid finish then 1 clearcoat,
|
|